VW T3 Vanagon Rear Speaker "fix" - image

Files (1)

Lautsprecher_einsatz_v6.stl

STL

25.7 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Lautsprecher_einsatz_v6.stl	Primary model	25.7 KB STL	Slice file	Slice file	Slice file	Trim the edges of the part with side cutters for a precise fit

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Interior

VW T3 Vanagon Rear Speaker "fix"

0 downloads47 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

Closes the holes i needed to cut into the speaker housings of my Caravelle GL in order to replace the old, defective "Blaupunkt" speakers with those new "Kicker" ones. Nearly any 79mm speaker should fit. Glued everything together with 2K Epoxy (like Volkswagen did back then) Trim the edges of the part with a pair of side cutters, so that it fits the shape of the hole you cut into the housing Print from PETG or higher temperature resistance (ABS? Nylon? ASA?) i used PETG.