Files (3)

3mm-v2-bottom_plate.stl

STL

11.8 KB

iPhone_center_console_dock_-_v2.step

STEP

452.6 KB

iphone_dock-v2.stl

STL

113.8 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

3 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 15%	100% solid	Recommendation
3mm-v2-bottom_plate.stl	Accessory piece	11.8 KB STL	Slice file	Slice file	Slice file	Small functional file: print slowly; consider 80–100% infill for durability.
iPhone_center_console_dock_-_v2.step	Printable file	452.6 KB STEP	Slice file	Slice file	Slice file	Verify orientation and support needs in your slicer before printing
iphone_dock-v2.stl	Printable file	113.8 KB STL	Slice file	Slice file	Slice file	Verify orientation and support needs in your slicer before printing

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Cup Holders

Tacoma iPhone dock

0 downloads45 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This is a docking station that fits in the middle of the front cup holder in a 2022 Tacoma (or any 4th gen). It is sized to fit an iPhone 12 Pro Max, but would probably fit the 13 & 14 Pro max as well. It replaces the OEM plastic divider and uses that slot as a friction fit, it needs to be tighter so that it doesn't pull out, but that is a WIP. I'm using a right-angle cable that is held tight to the base with a 3mm plate that fits over the connector. The plate can be made to fit very tightly with a bit of elephant foot, or an increased flow rate for the first couple of layers. This is the cable I use: https://www.amazon.com/gp/product/B07L81LLN2 Infill at 10-20% is fine, no supports are needed. Any suggestions or requests for different sizes are welcome.

Compatible Cars

Toyota Tacoma

Published Jun 29, 2026Updated Jul 15, 2026

Originally published on thingiverse.com by (PrefectPitch) · License: CC BY

Verified by drivers

Share whether this print actually fits a real car. Installed photos and material notes make the catalog more trustworthy.

Loading fitment proof…

Comments (0)

Part lists

Save this part to named public or private collections. Public lists can be shown on this part page.

Related Parts

Finding specific fitment/category matches first.