Tacoma Seatbelt holder (double and single) - image

Files (2)

double_Seat_Belt_Holder.stl

STL

16.7 KB

Seat_Belt_Holder-_fixed.stl

STL

16.7 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

2 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
double_Seat_Belt_Holder.stl	Mount / bracket	16.7 KB STL	Slice file	Slice file	Slice file	Small functional file: print slowly; consider 80–100% infill for durability.
Seat_Belt_Holder-_fixed.stl	Mount / bracket	16.7 KB STL	Slice file	Slice file	Slice file	Small functional file: print slowly; consider 80–100% infill for durability.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Interior

Tacoma Seatbelt holder (double and single)

0 downloads29 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This is a remix of the seatbelt holder for the Tacoma by ajsharp21 https://www.thingiverse.com/thing:286111. I corrected the original file which was non-manifold and had some internal geometry that affected printing. I also remixed the design to make a double seatbelt holder. This allows it to work on the side of the seat that has the center and side buckle right next to eachother. I printed this in PETG to better handle hot temps inside the truck when parked.