TEC Cup Holder Pad for BMW E39 5 Series M5 preview

Files (1)

TEC_Cup_Holder_Pad_-_Pad_Beveled.stl

STL

138.4 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	TPU 20%	TPU 40%	100% solid	Recommendation
TEC_Cup_Holder_Pad_-_Pad_Beveled.stl	Mount / bracket	138.4 KB STL	Slice file	Slice file	Slice file	Print with zero bottom layers to expose infill for a drip catch

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

TEC Cup Holder Pad for BMW E39 5 Series M5

0 downloads16 views0 quality score

Print this part

Check the available model and saved setup details before opening your slicer.

Files

1 hosted model file

STL

Material

TPU for flexibility and non-vibration surface

Print time

Slice to calculate

Filament

Slice to calculate

Supports

verify in slicer

Infill

medium to high infill for durability and 'catch' for drips

Difficulty

Not rated — inspect geometry

Vehicle heat

Flexible material; verify heat and load

Open the STL, 3MF, or OBJ model in your slicer before printing. Confirm orientation, supports, print time, filament use, and printer compatibility. Test-fit before installing it in a vehicle.

License & use

CC BY

Commercial use allowed

Attribution required

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

3DPrintedCarPart

Verified

Description

This is a pad that sits on the TEC folding cup holder for the BMW E39 5 series. I found that my preferred travel mug was slightly too large of a diameter to sit completely down in the cup holder. Print this in TPU and it will create a nice, non-vibration surface. You can also print with zero bottom layers to expose the infill, which could also create a nice "catch" for any errant drips. Category: Automotive.