Telsa model 3 phone holder holder - image

Files (2)

Tesla_HUD_phone_stand_High.stl

STL

1.2 MB

Tesla_HUD_phone_stand_low.stl

STL

1.1 MB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

2 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Tesla_HUD_phone_stand_High.stl	Printable file	1.2 MB STL	Slice file	Slice file	Slice file	Ensure a secure fit by adjusting the size according to your car's trim
Tesla_HUD_phone_stand_low.stl	Printable file	1.1 MB STL	Slice file	Slice file	Slice file	Ensure a secure fit by adjusting the size according to your car's trim

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Phone Mounts

Telsa model 3 phone holder holder

0 downloads34 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

William Harris wanted a generic holder and I wanted a specific holder for a Deltaco motorized wireless phone holder so that I could put Waze behind the wheel. So I "remixed" his design - that is I took the left rear leg from his design which fits neatly into an air outlet and added everything else;-). The result also clips around the metallic edge of the wood trim in the model 3 and is quite sturdy. Since the wood trim tapers off to the left and my design is intended to be clipped in slightly right off-center you might want to make it a little smaller if you want to position it dead center. The vapor smoothed ABS version fits well with the pre-2021 piano black trim. I also added a swan neck version to hold a phone in portrait mode but I find it a bit wobbly and use landscape mode anyway. You might want to adjust the size of the ball ti suit your phone holder or replace it with a magnet.

Compatible Cars

Tesla Model 3

Published Jun 29, 2026Updated Jul 15, 2026

Originally published on thingiverse.com by Carsten Cremer (CarstenMakerBot) · License: CC BY

Verified by drivers

Share whether this print actually fits a real car. Installed photos and material notes make the catalog more trustworthy.

Loading fitment proof…

Comments (0)

Part lists

Save this part to named public or private collections. Public lists can be shown on this part page.

Related Parts

Finding specific fitment/category matches first.