Files (1)

CarJackPadV2.stl

STL

83.7 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
CarJackPadV2.stl	Primary model	83.7 KB STL	Slice file	Slice file	Slice file	Ensure proper orientation to minimize supports

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Mechanical/Functional

Tesla Car Jack Pad

0 downloads34 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

A Tesla has an unusual jack point that means a normal round jack pad will not fit it, and will actually damage the battery if used directly. So I printed this. I included the source file so people could modify it if they wanted to. I am not sure if my jack pad is standard or not, I bought it at Canadian Tire which is usually pretty generic. The Tesla jack point has 3 holes, but I only included 2 posts because that is all that would fit under the circular jack pad. The middle hole is actually a bigger diameter than the 2 outside, but I decided to print both posts the same diameter.