Files (2)
Slice the required model files; source file size is not printable volume.
Use the slicer's filament total; STL/3MF byte size is not a cost input.
Slice with the recommended material, infill, orientation, and supports.
| STL file | Role | Source size | PETG / ASA 20% | PETG / ASA 25% | 100% solid | Recommendation |
|---|---|---|---|---|---|---|
| cover.STL | Cover / cap | 12.0 MB STL | Slice file | Slice file | Slice file | Use PETG / ASA; check sealing faces and verify in slicer. |
| lever.STL | Printable file | 20.4 MB STL | Slice file | Slice file | Slice file | Ensure proper alignment of the spring-loaded latch mechanism during printing and assembly |
Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.
Tesla Charger Hanger
Shared by
3DPrintedCarPartDescription
I drew up a hanger for the charger for my Tesla. It's not waterproof, but it's sufficiently water-resistant for outdoor use in the relatively dry place where I live. My original design held onto the connector with a passive hook, but the cable would drop if you bumped it so I added in a spring-loaded latch that you release with a trigger. It works beautifully. Requires two 3mm shafts (shaft stock, screws, nails, whatever) and a rubber band (I used a synthetic rubber o-ring).
Compatible Cars
Originally published on thingiverse.com by Travis Llado (tllado) · License: CC BY
Share whether this print actually fits a real car. Installed photos and material notes make the catalog more trustworthy.
Related Parts
Finding specific fitment/category matches first.
