Files (2)

Tesla_Drawer_Raw-200-124-50-With_Tesla_-2018.stl

STL

141.4 KB

Tesla_Drawer_Raw-200-124-50-With_Tesla_and_USCoins.stl

STL

226.9 KB

Print guidance estimate

Estimated from part metadata

Print cost & setup estimate

Planning numbers for filament, cost, time, and setup. Treat them as estimates until you confirm the file in your slicer.

2 model files

Typical selected file

17g

Based on 25% main infill for the largest likely-needed model file

Material cost

$0.41

Filament only at roughly $24/kg PETG / ASA

Print time

30m–49m

Uses 70 mm/s, 0.2 mm layers; verify supports in slicer

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Tesla_Drawer_Raw-200-124-50-With_Tesla_-2018.stl	Printable file	141.4 KB STL	14g $0.33	15g $0.36	32g $0.78	Ensure the model is oriented to minimize supports
Tesla_Drawer_Raw-200-124-50-With_Tesla_and_USCoins.stl	Printable file	226.9 KB STL	16g $0.38	17g $0.41	38g $0.91	Ensure the model is oriented to minimize supports

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Tesla Cubby with logo and naming on inside

0 downloads27 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

Added on the logo in the front, and the lettering on the inside. Updated the lettering on the inside it was not flush with the back wall, thanks for pointing it out.,.. Added a USCoins holder too.