Tesla J1772 Adapter Trunk Holder for Model 3/Model Y - image

Files (2)

Tesla-hpwc-model-s_block.stl

STL

40.9 KB

Tesla_Trunk_Electric_Open_With_Holder.stl

STL

102.7 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

2 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 60%	100% solid	Recommendation
Tesla-hpwc-model-s_block.stl	Printable file	40.9 KB STL	Slice file	Slice file	Slice file	Rotate the model to have the ring vertically for optimal print time and strength
Tesla_Trunk_Electric_Open_With_Holder.stl	Mount / bracket	102.7 KB STL	Slice file	Slice file	Slice file	Rotate the model to have the ring vertically for optimal print time and strength

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Organizers

Tesla J1772 Adapter Trunk Holder for Model 3/Model Y

0 downloads40 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

In the Model Y, there wasn't a good place to store the J1772 adapter. This design uses the charger emergency release compartment of the M3/MY as a place to clip in a holder. This design adds a completely form fitting for the Tesla HPWC style connector. I've included the OpenSCAD model I built for the Tesla Holder portion. Finally, there is a Blender file that has all the pieces put together in case you need to adjust a cllp or re-use the holder design. ## Installation Instructions To insert the holder, you will need a little pressure (it fits very snug so it won't fall out). To remove the holder, pull down on the ring. It may require a pry tool as it's a very snug fit. ## Printing Notes Cura slicing. 0.2mm, Supports Required, 60% In-Fill Rotated to have the ring vertically. This is optimal print time, but, also provides strength and support for the clips.