Tesla Model 3 Center Console Tray (Modified from jonco223) - image

Files (1)

Tesla_M3_Center_Console_Tray_Mod.stl

STL

1.0 MB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Tesla_M3_Center_Console_Tray_Mod.stl	Primary model	1.0 MB STL	Slice file	Slice file	Slice file	Ensure proper adhesion to prevent warping

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Center Console

Tesla Model 3 Center Console Tray (Modified from jonco223)

0 downloads26 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This is a center console tray (with coin tray) remix from jonco223's design. The original design is great but I just have some pet peeves that I needed to modify... The following are the modifications: 1. Fix - The wall thickness below the coin tray is too thin for 0.4mm nozzle to print, I was getting a pin-hole in my original print. 2. Fix - The step-down from the top ledge is rubbing against the center console cover. I recessed it back 10mm. This problem will show up if you plan on flocking the tray - the rubbing will rub off the flocking fibers and the paint. 3. Mod - Added a partial opening in the front of the tray to allow cable or light to come thru from the bottom of the center console. 4. Mod - Rounded out most of the straight edges in the tray as (and I'm still learning) sharp corners don't stick to flocking fibers too well.