Tesla Model 3 console tray with coin holder preview

Files (1)

Model_3_with_coin_tray.stl

STL

115.7 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Model_3_with_coin_tray.stl	Primary model	115.7 KB STL	Slice file	Slice file	Slice file	Check final orientation and support decisions in your slicer

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Tesla Model 3 console tray with coin holder

0 downloads12 views0 quality score

Print this part

Check the available model and saved setup details before opening your slicer.

Files

1 hosted model file

STL

Material

PETG or ASA

Print time

Slice to calculate

Filament

Slice to calculate

Supports

verify in slicer

Infill

20-30% infill for durability

Difficulty

Not rated — inspect geometry

Vehicle heat

Cabin/interior use; avoid high-heat zones

Open the STL, 3MF, or OBJ model in your slicer before printing. Confirm orientation, supports, print time, filament use, and printer compatibility. Test-fit before installing it in a vehicle.

License & use

CC BY

Commercial use allowed

Attribution required

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

3DPrintedCarPart

Verified

Description

I liked the bin size and shape made by jonco223 ( https://www.thingiverse.com/jonco223 ) and the coin holder by tp1996 ( https://www.thingiverse.com/tp1996 ) so I decided to put them together. The picture shows the coin holder printed a little too high, so I edited it so that it sits a little further down into the tray. I didn't remove the small jonco223 coin holder as it could be used for other small items. The gap between the sunglasses wall and the coin holder was intentional in case there is something else you want to drop in there that won't roll around and scratch up your sunglasses. Print Settings Printer Brand: Prusa Printer: I3 MK3S Rafts: No Supports: No Resolution: 0.2 mm Infill: 20% Filament: eSun PLA+ Black Notes: 0.4 mm nozzle Category: Automotive.