Tesla Model 3 Raspberry Pi Holder - image

Files (1)

Tesla_Raspberry_Pi_Holder_20-06-29.stl

STL

11.7 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Tesla_Raspberry_Pi_Holder_20-06-29.stl	Mount / bracket	11.7 KB STL	Slice file	Slice file	Slice file	Small functional file: print slowly; consider 80–100% infill for durability.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Center Console

Tesla Model 3 Raspberry Pi Holder

0 downloads35 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

I started using a Raspberry Pi as a dashcam and music storage device in my Tesla Model 3. (Shoutout to Marcone for managing this github https://github.com/marcone/teslausb) But I was unhappy with the case holding the Pi just floating around the center console of the car. So I decided to make a holder for it. This holder is mounted to the front of the compartment by the usb plugs. No screws needed. double sided tape could be used if desired. This version includes some wire management struts in case your wires are too long. I designed this to work with a Raspberry Pi Zero W mounted in Vilros case. But there is room built-in for several different case designs up to 22mm tall x 83mm wide x 37mm across.