Tesla Model S Console Cup Holder - image

Files (1)

tesla_model_s_console_cup_holder.stl

STL

426.2 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
tesla_model_s_console_cup_holder.stl	Mount / bracket	426.2 KB STL	Slice file	Slice file	Slice file	Verify orientation and supports in slicer before printing

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Cup Holders

Tesla Model S Console Cup Holder

0 downloads32 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This is hopefully an improvement to the existing cup holder on the Tesla model s. I designed this for a Tesla Model S 2016, but it should fit 2016-2018. I've provided measurements in the drawing below, so please measure to confirm before printing this, since this will be a long print, at at least 17 hours on most 3D printers. Important note. The console sliding cover will not close when this is installed. This is not intended to be permanent. Please see the picture that shows how this fits in the car. Print without supports.