Files (1)

craTeslaNutCapRemover.stl

STL

48.5 KB

Print guidance estimate

Estimated from part metadata

Print cost & setup estimate

Planning numbers for filament, cost, time, and setup. Treat them as estimates until you confirm the file in your slicer.

1 model file

Recommended kit

11g

Based on 25% main infill across listed model files

Material cost

$0.26

Filament only at roughly $24/kg PETG / ASA

Print time

19m–31m

Uses 70 mm/s, 0.2 mm layers; verify supports in slicer

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
craTeslaNutCapRemover.stl	Cover / cap	48.5 KB STL	10g $0.24	11g $0.26	24g $0.58	Use PETG / ASA; check sealing faces and verify in slicer.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Tools & Jigs

Tesla nut cap remover

0 downloads105 views0 likes

Shared by

Alfred

Verified

Description

When I went to tighten the wheel nuts on my car I discovered that the rims on my winter wheels had a deeper design then the summer wheels, and I couldn't reach the decorative/protective caps with my fingers. I couldn't find a tool for removing them, so I set out to design and print one myself. It is the first actually useful thing I have created in Fusion 360. It's probably obvious I'm a noob at 3D design, but the tool worked great for me and served the purpose beautifully. I added the chamfers after printing and using my own tool, as I found out it was a bit tight between the caps and edge of the hole so I had to file away a little material. The current design should address this issue so you won't have to.