Toyota 60-series Land Cruiser Cup Holder - image

Files (1)

fj60_cup_holder.stl

STL

1.3 MB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
fj60_cup_holder.stl	Mount / bracket	1.3 MB STL	Slice file	Slice file	Slice file	Ensure a brim or raft is used for better adhesion

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Cup Holders

Toyota 60-series Land Cruiser Cup Holder

0 downloads37 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This is a cup holder insert I whipped up that fits in the front compartment of the factory 60-series center console. It has two cup holders and a center slot to hold a smartphone vertically. The cup holders securely hold cans up to 23oz, 20oz soda bottles, and anything else up to 72mm in diameter. The phone slot holds my Galaxy S6 with no case with plenty of wiggle room, and should fit cases up to 72mm wide and 10mm thick. It could probably be scaled to 102-103% for a little extra room, but I haven't tested that yet. It's secured in the compartment by velcro, but double-sided foam tape or magnetic tape would also work. I also lined the bottom of each section with adhesive foam to reduce noise from my aluminum water bottle vibrating, which is optional but recommended. Enjoy!