Toyota Sequoia phone mount for SR5 - image

Files (2)

LR_phoneside1.stl

STL

516.2 KB

sequoia_phone_mount_1.stl

STL

490.9 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

2 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
LR_phoneside1.stl	Printable file	516.2 KB STL	Slice file	Slice file	Slice file	Ensure proper orientation in the slicer to minimize supports
sequoia_phone_mount_1.stl	Mount / bracket	490.9 KB STL	Slice file	Slice file	Slice file	Ensure proper orientation in the slicer to minimize supports

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Phone Mounts

Toyota Sequoia phone mount for SR5

0 downloads33 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

A phone mount to fit my SR5 Sequoia, wont fit the platinum (not sure about the limited) because the little pocket that this takes advantage of is not found in those trim levels (its where the air suspension controls are). Just need some supports on the "phone side" part for the little lip that holds the bottom of the phone in place. The vehicle side can print without supports. Fits a cheap Qi charger (a few $ on aliexpress). Glue the two halves together. might might change the file to move the assembly inward a bit, right now its a little close to your knee.