Toyota Tacoma 2nd Gen (2005-2011) Grille Emblem - image

Files (3)

Tacoma_2nd_Gen_Grille_Badge_1-piece.stl

STL

258.2 KB

Tacoma_2nd_Gen_Grille_Badge_Logo_Part.stl

STL

174.8 KB

Tacoma_2nd_Gen_Grille_Badge_rear_part.stl

STL

50.3 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

3 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Tacoma_2nd_Gen_Grille_Badge_1-piece.stl	Printable file	258.2 KB STL	Slice file	Slice file	Slice file	Ensure proper layer adhesion for a strong bond between colors if using the 1-piece file with layer change
Tacoma_2nd_Gen_Grille_Badge_Logo_Part.stl	Printable file	174.8 KB STL	Slice file	Slice file	Slice file	Ensure proper layer adhesion for a strong bond between colors if using the 1-piece file with layer change
Tacoma_2nd_Gen_Grille_Badge_rear_part.stl	Printable file	50.3 KB STL	Slice file	Slice file	Slice file	Ensure proper layer adhesion for a strong bond between colors if using the 1-piece file with layer change

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Emblems/Badges

Toyota Tacoma 2nd Gen (2005-2011) Grille Emblem

0 downloads32 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

Replacement Toyota emblem for a 2nd generation (2005-2011) Tacoma. The back "fill" piece has two slots built in for cable ties to pass through to secure to the grille. I have included a 1 piece file which you can do a layer change on for the different colors, or 2 separate pieces if you prefer to print them separately and glue them together after May also fit the facelifted 2.5 Gen Tacoma as well (2012-2015) but I cannot verify fitment.