Volkswagen MK1 Rabbit/Jetta Center Console with Can Holders preview

Files (1)

Cup_Holder_v1.stl

STL

511.3 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Cup_Holder_v1.stl	Mount / bracket	511.3 KB STL	Slice file	Slice file	Slice file	Ensure proper orientation in the slicer for optimal support generation

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Volkswagen MK1 Rabbit/Jetta Center Console with Can Holders

0 downloads53 views0 quality score

Print this part

Check the available model and saved setup details before opening your slicer.

Files

1 hosted model file

STL

Material

PETG or ASA for durability in a car environment

Print time

Slice to calculate

Filament

Slice to calculate

Supports

verify in slicer

Infill

20-30% infill for a balance between strength and weight

Difficulty

Not rated — inspect geometry

Vehicle heat

Cabin/interior use; avoid high-heat zones

Open the STL, 3MF, or OBJ model in your slicer before printing. Confirm orientation, supports, print time, filament use, and printer compatibility. Test-fit before installing it in a vehicle.

License & use

CC BY

Commercial use allowed

Attribution required

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

3DPrintedCarPart

Verified

Description

Cup holders for your MK1! This uses the cabriolet style shift boot, kinda. I also made the cup holes a little small, it fits a can tightly. A water bottle will fit, but the tapered mcdonalds cups or anything else probably wont. It's not totally perfect, but it's good enough for me. 4/14/23: I added another section of tray that will hold a usb charger. I also added seat heater switch holes to the cup holder. And added a couple of less disgusting pictures. Category: Automotive.