Files (2)

nut_cover.STL

STL

127.5 KB

wiper_arm_mount.STL

STL

277.9 KB

Print guidance estimate

Estimated from part metadata

Print cost & setup estimate

Planning numbers for filament, cost, time, and setup. Treat them as estimates until you confirm the file in your slicer.

2 model files

Typical selected file

19g

Based on 25% main infill for the largest likely-needed model file

Material cost

$0.45

Filament only at roughly $24/kg PETG / ASA

Print time

32m–53m

Uses 70 mm/s, 0.2 mm layers; verify supports in slicer

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
nut_cover.STL	Cover / cap	127.5 KB STL	13g $0.32	14g $0.34	31g $0.75	Use PETG / ASA; check sealing faces and verify in slicer.
wiper_arm_mount.STL	Mount / bracket	277.9 KB STL	17g $0.41	19g $0.45	41g $0.98	Ensure proper orientation to minimize supports

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Mechanical/Functional

Volvo rear wiper arm mount

0 downloads33 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

For Volvo V40 1995-2004 model. May fit also other models equipped with tapered shaft and M8 nut. You need to remove the brass taper insert from the old part and insert into the new one using heat. 1 x M3-20 screw and 1 x M3 threaded insert is required for assembly.