VOLVO XC90 Phone Holder for HTC U11 in rugged skin - image

Files (4)

dash-mount-locker.stl

STL

13.3 KB

dash-mount.stl

STL

152.2 KB

HTC-U11-in-rugged-skin-holder.stl

STL

439.1 KB

wire-holder.stl

STL

158.9 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

4 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
dash-mount-locker.stl	Mount / bracket	13.3 KB STL	Slice file	Slice file	Slice file	Small functional file: print slowly; consider 80–100% infill for durability.
dash-mount.stl	Mount / bracket	152.2 KB STL	Slice file	Slice file	Slice file	Ensure a strong adhesion to the print bed to prevent warping
HTC-U11-in-rugged-skin-holder.stl	Mount / bracket	439.1 KB STL	Slice file	Slice file	Slice file	Ensure a strong adhesion to the print bed to prevent warping
wire-holder.stl	Mount / bracket	158.9 KB STL	Slice file	Slice file	Slice file	Ensure a strong adhesion to the print bed to prevent warping

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Phone Mounts

VOLVO XC90 Phone Holder for HTC U11 in rugged skin

0 downloads52 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

Long time I thought about a good phone holder for my HTC U11 in my Volvo XC90 '13. The idea was: to put the phone near my hands and on the line of the dashboard. Mount stand must not leave any signs in case of removal. The power cable must be connected to the phone each time when it comes to the holder. My phone covered by a rugged cover and the holder must fit it too. The solution is in this model and some additional parts were used for mounting: 1) 3M Vynil tape 2) screws M3x16 - 3pcs, M3x12x4pcs nuts M3 7pcs 1 washer + 1 washer grover 3) 150mm of nickel tab tape 2P 18650 with 0.15mm thickness. To have a good connection I used a cheap magnetic USB cable with USB-C adaptor.