Volvo V40 phone mount for centre console - image

Files (2)

S10_phone_holder_to_go_onto_the_V40_phone_mount.stl

STL

143.1 KB

Volvo_V40_phone_bracket_mount.stl

STL

45.4 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

2 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 20%	100% solid	Recommendation
S10_phone_holder_to_go_onto_the_V40_phone_mount.stl	Mount / bracket	143.1 KB STL	Slice file	Slice file	Slice file	Scale the model to 10% in the slicer if it appears oversized
Volvo_V40_phone_bracket_mount.stl	Mount / bracket	45.4 KB STL	Slice file	Slice file	Slice file	Scale the model to 10% in the slicer if it appears oversized

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Phone Mounts

Volvo V40 phone mount for centre console

0 downloads46 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

Was looking for a phone mount to go near the centre console but couldnt find anything for the V40 so I made my own. This is made with a Samsung S10 in mind and it was made slightly wide incase I wanted a case on the phone, also wanted to have access to the bottom to be able to charge it if needed. To bolt it to the car it uses the existing Torx screw that is there, there are then 2 M5x20 bolts and locknut nuts on it, I could have done it with just 1 bolt and nut but I wanted to make sure its super secure Printing I have used Gyroid and 20% infill to make it a little thicker. I printed it on a.8mm nozzle for time and will do some post work to make it smooth on the sides that are visible however if you use a smaller nozzle your lines wont be as defines. SCALING. The phone mount may come out way oversize, just scale it to 10% in Cura and it will be the correct size:).