VW Polo Dash Cell and GPS holder - image

Files (1)

Garmin_GPS_Suction_bed_v8_cell_lock_bars_hold_downs_big_ring.stl

STL

431.3 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	ABS / ASA 20%	ABS / ASA 40%	100% solid	Recommendation
Garmin_GPS_Suction_bed_v8_cell_lock_bars_hold_downs_big_ring.stl	Primary model	431.3 KB STL	Slice file	Slice file	Slice file	Use a wide brim for better adhesion

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Dashboard

VW Polo Dash Cell and GPS holder

0 downloads70 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

VW Polo dash GPS and Cell holder with bars. Fits into the hole in the dashboard of the older 2008 Polos. May fit in other cars as well. Do no require a smooth surface for the suction cups as the bars will hold it down. You need to push the bars into the holes to keep the gps holder down. Similar for the cell phone holder. you push the bars through the holes in the most left and right pillars to keep the cell in place. This was done for a Nokia Lumia 830 but the bars are flexible so may fit other makes. Print in ABS due to the heat on a car dashboard. Use wide brim. 30 to 50% infill should be fine but I prefer 100% infill. The extra tabs around the base is to further keep it down because the ABS tends to warp due to the large flat base. You can just cut or break these off.