VW Touareg Tailgate/Boot Latch Gear - image

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

0 model files

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PLA / nylon-based filament 20%	PLA / nylon-based filament 40%	100% solid	Recommendation
No printable model files are available for an estimate yet.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Trunk/Tailgate

VW Touareg Tailgate/Boot Latch Gear

0 downloads32 views0 likes

Download at source

Shared by

3DPrintedCarPart

Verified

Description

Replacement gear for VW Touareg tailgate/boot latch. As this part is quite small and intricate, I'd recommend printing slower to avoid the hotend pulling on the part at higher speeds. You may need to file some of the edges to ensure a smooth and clean fit but it also depends on how well you can print the part. I had better results with the overhangs using 0.2mm layer heights. PLA was the end result. I tried PETG but it's quite soft compared to PLA and tends to get pulled around a bit. I'd recommend PLA or a nylon based (the original part is nylon) filament although I haven't personally tried nylon.