WRX Cobb Accessport Defrost Mount - image

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

0 model files

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
No printable model files are available for an estimate yet.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Vents

WRX Cobb Accessport Defrost Mount

0 downloads44 views0 likes

Download at source

Shared by

3DPrintedCarPart

Verified

Description

This is a 2015+ WRX defroster vent mount for a Cobb Accessport remixed from dasfruit. I added vent fins, enclosed the portion of the mount around the cable holder, and added a clip to keep the cable from coming out of the mount. I also added tabs to help keep the mount from coming out of the dash, but it's still a work in process. You may need to file the rear tabs to allow proper fitment. Installation Instructions: 1. Run the cable up through the bottom of the mount 2. Slide the connector into the cable holder 3. Push the cable holder down through the mount 4. Place the cable holder clip around the cable holder coming out the bottom of the mount.