Files (3)

Phone_Base.stl

STL

57.6 KB

Phone_Top.stl

STL

45.6 KB

Phone_Top_Cover.stl

STL

4.6 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

3 model files

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Phone_Base.stl	Printable file	57.6 KB STL	Slice file	Slice file	Slice file	Ensure proper adhesion to prevent warping in high-temperature conditions
Phone_Top.stl	Printable file	45.6 KB STL	Slice file	Slice file	Slice file	Ensure proper adhesion to prevent warping in high-temperature conditions
Phone_Top_Cover.stl	Cover / cap	4.6 KB STL	Slice file	Slice file	Slice file	Small functional file: print slowly; consider 80–100% infill for durability.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Phone Mounts

Xterra (2005+) phone holder

0 downloads45 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

Remix to make the holder universal. Using magnets in the top. Use a phone case with a metal plate that works with other magnetic mounts. I used the magnets out of an old air vent mount I had laying around. The cover is glued in place and definitely needed. After parking In direct sun I had it actually shoot a magnet at me without it! It's been in use for about 6 months and over some rough (4x4 only) roads with no issues. Remix of the base adds a slot for the USB cable to enter.