1950 Studebaker Escutcheon insert - image

Files (1)

Escutcheon_Insert_Door_Handle_1950.stl

STL

1.4 MB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Escutcheon_Insert_Door_Handle_1950.stl	Primary model	1.4 MB STL	Slice file	Slice file	Slice file	Ensure a brim or raft for stability if necessary

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Door Handles

1950 Studebaker Escutcheon insert

0 downloads160 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

For the restoration of my 1950 Studebaker Commander I needed new inserts for the escutcheons for the door handle and window handle as seen on the photo. The old plastic is brittle and ugly after 65 years of service. This is a replacement for them. Sand down the flat top, spray with a good clearcoat paint and you are ready for another 65 years Studebaker part number 285580X3. You will need 8 of them.