2014 Toyota Rav4 dashboard trim phone mount, Quadlock compatible preview

Files (1)

rav4-phone-holder-v4_quadlock.stl

STL

624.6 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG 20%	PETG 25%	100% solid	Recommendation
rav4-phone-holder-v4_quadlock.stl	Mount / bracket	624.6 KB STL	Slice file	Slice file	Slice file	Use a foam strip on the bottom to avoid scratches and rattling on the trim piece

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

2014 Toyota Rav4 dashboard trim phone mount, Quadlock compatible

0 downloads4 views0 quality score

Print this part

Check the available model and saved setup details before opening your slicer.

Files

1 hosted model file

STL

Material

PETG

Print time

Slice to calculate

Filament

Slice to calculate

Supports

verify in slicer

Infill

20-30% infill for durability, with 2-3 walls for strength

Difficulty

Not rated — inspect geometry

Vehicle heat

Cabin/interior use; avoid high-heat zones

Open the STL, 3MF, or OBJ model in your slicer before printing. Confirm orientation, supports, print time, filament use, and printer compatibility. Test-fit before installing it in a vehicle.

License & use

Public Domain

Commercial use allowed

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

3DPrintedCarPart

Verified

Description

To complete one mount You will need: rav4-phone-holder-v4_quadlock (one piece, I do not recommend to print this due to the lost details of the splined portion which is the interface for the Quadlock system). or: rav4-phone-holder-v4_base or rav4-phone-holder-v4 with hook AND rav4-phone-holder-v4 Splined part, these pieces You need to glue together, the 3 holes are for pieces of filament to make the bond a bit stonger. Additional hardware: M5 nut Foam strip on bottom 3-4 mm thick to avoid scratches and rattling on the trim piece. Note: I included the rest of the system just in case. The “top” and "base for retainer" pieces are not compatible with the original product, only the splines are the same (or close enough). If You want to use the “retainer” piece, You should find or fabricate a spring for that for example from a piece of steel wire. Preinted from eSun Black PETG.