2015+ Subaru WRX accessory button cable passthrough - image

Files (1)

AccessoryBtnCablePassthrough_v1.stl

STL

1.2 MB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
AccessoryBtnCablePassthrough_v1.stl	Primary model	1.2 MB STL	Slice file	Slice file	Slice file	Ensure proper fitment by checking the dimensions against your vehicle's accessory panel

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Knobs/Buttons

2015+ Subaru WRX accessory button cable passthrough

0 downloads37 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This is a replacement for the OEM accessory button in 2015+ Subaru WRX’s to allow a cable of your choosing through. Fitment is only confirmed on the 2020 WRX but I believe it is the same from 2015 and up —To remove the OEM placeholder is a bit of a pain but not to hard.— There are small detents on the insert itself that click in on that accessory panel. There are 2 on top and 1 on the bottom when looking at it from behind. The best way to get the OEM insert out is to get 2 thin pieces of something and wedge one on top and one on the bottom and the push from the front of the insert inward and maybe wiggle until it slides out. Its tight so take your time. Once its out the 3d printed one sits securely but will easily push back out. Filament: Matterhackers MH-build ABS Infill: 20% Nozzle temp: 260 Bed Temp: 110 Layer Height:.16 Cooling: off Plate adhesion: Brim Wall line count: 3