Slice the required model files; source file size is not printable volume.
Use the slicer's filament total; STL/3MF byte size is not a cost input.
Slice with the recommended material, infill, orientation, and supports.
| STL file | Role | Source size | PETG / ASA 20% | PETG / ASA 25% | 100% solid | Recommendation |
|---|---|---|---|---|---|---|
| No printable model files are available for an estimate yet. | ||||||
Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.
82-92 Camaro/Firebird Rear Interior Trim Nut
Shared by
3DPrintedCarPartDescription
This is a direct replacement for the nylon trim nuts that hold the hatch area panels on. Nut.stl is for the 6 plastic screws that reatin the spare wheel cover and rear panel. Push-Pin_Nut.stl is for the three 8mm push pins that retain the driver side panel. You will need to print two Clip.stl per Nut.stl/Push-Pin_Nut.stl. Push the two clip pieces into the main body from the underside, they should be a tight friction fit and should not require glue. If they cannot be inserted by hand or with mild squeezing from pliers, check your horizontal expansion and other dimensional accuracy related settings. Wiggle assembly up and down while pushing into the back of the holes during installation.
Compatible Cars
Originally published on thingiverse.com by Braeden Canik (Lykoloo) · License: CC BY-NC
Share whether this print actually fits a real car. Installed photos and material notes make the catalog more trustworthy.
Related Parts
Finding specific fitment/category matches first.
