991 Porsche 911 speaker adapters - image

Files (3)

4inch-v3.stl

STL

65.2 KB

e430-v3.stl

STL

163.7 KB

md102-v4.stl

STL

92.7 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

3 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
4inch-v3.stl	Printable file	65.2 KB STL	Slice file	Slice file	Slice file	Ensure proper orientation in slicer for optimal support generation
e430-v3.stl	Printable file	163.7 KB STL	Slice file	Slice file	Slice file	Ensure proper orientation in slicer for optimal support generation
md102-v4.stl	Printable file	92.7 KB STL	Slice file	Slice file	Slice file	Ensure proper orientation in slicer for optimal support generation

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Door Panels

991 Porsche 911 speaker adapters

0 downloads38 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This is a speaker adapter for tweeters & 4-inch speakers in my 991 911. The 4" adapters fit both the door 4" mids & the rear 4" mids. You'll need the Burmester grills (or modify your Bose or SPP grills) to use this tweeter mount. There are 4" versions for the Dayton Audio RS100 and RS100p speaker, and the Dynaudio E430. The E430 drawing has insets for 3mm bolts, to allow easy mounting (no drilling & tapping holes for the speaker, like on the DA adapter). The tweeter adapter is for a Dynaudio MD-102 tweeter. It comes in two pieces; otherwise the overhangs are too severe to print. You join the two pieces together with adhesive before mounting the speaker. You'll also need to remove the tweeter from the shell it's shipped in; use an Allen wrench to unscrew the bolt, and it'll drop right out.