Files (1)

AC_Vent_V4.stl

STL

224.6 KB

Print guidance estimate

Uses saved filament metadata

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

50g

Based on 25% main infill across listed model files

Material cost

$1.20

Filament only at roughly $24/kg PETG

Print time

2.0h saved / 1.4h–2.4h estimate

Uses 70 mm/s, 0.2 mm layers; verify supports in slicer

STL file	Role	Source size	PETG 20%	PETG 25%	100% solid	Recommendation
AC_Vent_V4.stl	Primary model	224.6 KB STL	46g $1.10	50g $1.20	110g $2.63	Ensure proper orientation in slicer for optimal print quality

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Interior

AC Vent Deflector

0 downloads136 views0 likes

Shared by

Michael Chen

Verified

Description

I got sick of my AC vent pumping air into the bottom of my mattress. I designed this to change the direction of the air, to shoot out at a 90 degree angle. I have planned this to attach a 4" vent tube, which will bring the air out to the side of the bed. Print two, so it can shoot out each direction. If you only print one, there will be no pressure to send air through the tube. I designed this to hold some little magnets I had (round, 12 mm diameter x 2 mm thick). The magnets are supposed to hold the printed parts onto the vent cover, and also to hold both printed pieces together. The magnets will probably not cut it, and an update will eventually help it hold better to the vent cover. So will duct tape. AC Tubing: https://www.amazon.com/dp/B07WRDTX4C?ref=ppx_pop_mob_ap_share Generic vent cover for 12"x4" hole in the floor: https://www.amazon.com/gp/product/B00188C1HS/ref=ppx_yo_dt_b_asin_title_o04_s00?ie=UTF8&psc=1