Files (1)

phone_holder.stl

STL

143.9 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
phone_holder.stl	Mount / bracket	143.9 KB STL	Slice file	Slice file	Slice file	Ensure the phone stand's pin diameter matches the 6mm requirement

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Phone Mounts

Astra J Phone Stand

0 downloads81 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

Opel Astra J has a big issue when it comes for adding a phone stand since the blades of the airducts are vertical and cannot keep a good position. The pin is 6mm in diameter. This modeling started from https://www.thingiverse.com/thing:2538673. Also the design file is attached in case additional changes are needed - is a Sketchup Maker 2017 file. This design is using the edge of the multimedia area and is offering a generic pin which can be used as you need. In my case I've used a generic/cheap magnetic holder resulting in a very small and nice phone stand.