iPhone MagSafe dock for Opel/Vauxhall Astra G - image

Files (2)

MagSafeAstra_v4.stl

STL

1.2 MB

MagSafeAstra_v4_fixed-5.stl

STL

379.3 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

2 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
MagSafeAstra_v4.stl	Printable file	1.2 MB STL	Slice file	Slice file	Slice file	Ensure a tight fit for the MagSafe charger
MagSafeAstra_v4_fixed-5.stl	Printable file	379.3 KB STL	Slice file	Slice file	Slice file	Ensure a tight fit for the MagSafe charger

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Phone Mounts

iPhone MagSafe dock for Opel/Vauxhall Astra G

1 downloads59 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

A MagSafe Dock for the new iPhone 12 devices designed for the Opel/Vauxhall Astra G. The dock replaces one of the vents in the center console (if flipped, you could probably also replace the vent left of the steering wheel). The MagSafe charger fits very tightly – I had to apply quite a bit of force and I doubt it will go anywhere, so no screws or glue needed. There are two files: My original design and a version fixed by Netfabb (which caused the hole in the front to close, but that has not been an issue for me). For size reference: The iPhone in the picture is the 12 Mini.