Files (1)

audi_wheel_cap_60mm.stl

STL

971.2 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
audi_wheel_cap_60mm.stl	Cover / cap	971.2 KB STL	Slice file	Slice file	Slice file	Use PETG / ASA; check sealing faces and verify in slicer.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Emblems/Badges

Audi logo wheel cap

0 downloads32 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

Actual diameter is roughly 29mm, it fits perfectly, doesn't pop out, has a little cut on the side to pop them out when needed with a flat screwdriver. Was designed specifically for the rim in the picture, but it's a common design so maybe it fits more types of rims, maybe only by scaling mine to the needed diameter of yours. EDIT: replaced the STL with another which has pointier clamp heads so it slides in better, unlike the one in my hand in the picture.