BMW Rear Bolster Clip 52 20 9099555 - image

Files (1)

rear_bolster_clip.stl

STL

14.9 KB

Print guidance estimate

Estimated from part metadata

Print cost & setup estimate

Planning numbers for filament, cost, time, and setup. Treat them as estimates until you confirm the file in your slicer.

1 model file

Recommended kit

Based on 25% main infill across listed model files

Material cost

$0.22

Filament only at roughly $24/kg PETG / ASA

Print time

15m–26m

Uses 70 mm/s, 0.2 mm layers; verify supports in slicer

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
rear_bolster_clip.stl	Clip	14.9 KB STL	8g $0.20	9g $0.22	20g $0.47	Small functional file: print slowly; consider 80–100% infill for durability.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Interior

BMW Rear Bolster Clip 52 20 9099555

0 downloads39 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

Replacement for BMW 52 20 8099555 rear seat side bolster clip Designed for my e46 m3 after the clip broke when removing the bolster panel and I found how absurdly expensive a replacement clip was to obtain, but likely fits other e46 3 series, e53 x5, e81 1 series and e92 3 series models too. Printed in PLA+, but would recommend using a higher temperature filament like PETG or nylon if available. Might require some very slight modification to work on your specific car depending on printer tolerances.