Files (4)

BC_B1.stl

STL

274.2 KB

BC_B2.stl

STL

357.5 KB

camera_plate_support_1.stl

STL

308.5 KB

camera_plate_test_6.stl

STL

1.8 MB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

4 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
BC_B1.stl	Printable file	274.2 KB STL	Slice file	Slice file	Slice file	Ensure proper orientation in the slicer for optimal printing and minimal supports
BC_B2.stl	Printable file	357.5 KB STL	Slice file	Slice file	Slice file	Ensure proper orientation in the slicer for optimal printing and minimal supports
camera_plate_support_1.stl	Printable file	308.5 KB STL	Slice file	Slice file	Slice file	Ensure proper orientation in the slicer for optimal printing and minimal supports
camera_plate_test_6.stl	Printable file	1.8 MB STL	Slice file	Slice file	Slice file	Ensure proper orientation in the slicer for optimal printing and minimal supports

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Exterior

C5 Corvette Backup Camera

0 downloads39 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

I was looking to add new car stereo to my 2002 C5 Corvette. As part of it was a backup camera option. I looked at a lot different camera's they all had some ugly bracket that you had to make extra holes in car or that ugly crap on license plate. (altho the bracket thing around my license plat is ugly I should change it) They all stand out and do not look like they belong on the car. So I made one. I used cars stock license plate light screws and 4 M3 screws 2 25mm 2 20 mm. (I used screws I had sitting around length not super important) I used Natika WD-012 camera kit from amazon Link below I finished the from and all visible edges using automotive primer/filler. Painted with torch red and clear coated. I sanded all visible surfaces and edge. I was not picky about the smoothness of the areas and parts that were not visible after install. So if you make this item it comes in any color you want along as it is touch red when your done! https://www.amazon.com/Backup-Front-Side-View-Camera/dp/B083SF5VVN/ref=pb_allspark_dp_session_sims_pao_desktop_4/131-5201489-0299864?pd_rd_w=uC8U9&pf_rd_p=3ac2ce50-9d75-4bd3-868d-72b252a0623c&pf_rd_r=PCV3VWY5RGGVHWTKD8HQ&pd_rd_r=e48847e9-6af7-4c51-bda6-9cdfebdbdd7c&pd_rd_wg=TKuWF&pd_rd_i=B083SF5VVN&psc=1