Camera Mount - Fiat Ducato, Peugeot Boxer, Citroen Jumper - image

Files (3)

camera_cover.stl

STL

406.1 KB

camera_mount_lh_1.stl

STL

544.8 KB

camera_mount_rh.stl

STL

519.1 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

3 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
camera_cover.stl	Cover / cap	406.1 KB STL	Slice file	Slice file	Slice file	Use PETG / ASA; check sealing faces and verify in slicer.
camera_mount_lh_1.stl	Mount / bracket	544.8 KB STL	Slice file	Slice file	Slice file	Ensure proper adhesion to the print bed to prevent warping
camera_mount_rh.stl	Mount / bracket	519.1 KB STL	Slice file	Slice file	Slice file	Ensure proper adhesion to the print bed to prevent warping

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Accessories

Camera Mount - Fiat Ducato, Peugeot Boxer, Citroen Jumper

0 downloads50 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

Used the original file for the brake light housing and modified it a bit. Now has a groove for a rubber sealer/gasket. Now single, rectangular camera for parking - angled down for perfect parking angle. Camera Cover needs to be glued on or held with magnets. Obey the description from the original file for screw length and also print the extension blocks from the original design.