Files (1)
Slice the required model files; source file size is not printable volume.
Use the slicer's filament total; STL/3MF byte size is not a cost input.
Slice with the recommended material, infill, orientation, and supports.
| STL file | Role | Source size | PETG / ASA 20% | PETG / ASA 85% | 100% solid | Recommendation |
|---|---|---|---|---|---|---|
| Portagekeil_4.stl | Primary model | 35.6 KB STL | Slice file | Slice file | Slice file | Ensure proper adhesion to the print bed to prevent warping |
Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.
Unterlegekeil (Chock) für (for) Thule 819 - Kanuhalter auf (for) Citroen original Dachträger (Roofrack) für Citroen Berlingo
Shared by
3DPrintedCarPartDescription
Der Original-Dachträger von Citroen führt bei den Kanuhaltern von Thule dazu, dass diese nach hinten abfallen und das Kanu nicht schön aufliegt. Dieser Unterlegkeil begradigt dies. Der Keil ist (mangelndem Skill geschuldet) eine bloße Annäherung an das Trägerprofil, aber gut genug für den Zweck. Unbedingt darauf achten, dass man ordentlich Infill verwendet, da das Teil stark komprimiert wird. (ich nahm 90%) The original Roofrack from Citroen lets the Canoeholders from Thule mount at an angle to the Back. So a Canoe won't rest on them as it should. This Chock fixes that. The Chock is (due to a lack of skill) an aproximation to the Crossbar-Profile, but it does the Trick. When setting up the Infillparameters - keep in Mind, that the Part will be compressed quite bit... I did it with 90%.
Compatible Cars
Originally published on thingiverse.com by Eugene van der Mill (EugeneVanDerMill) · License: CC BY
Share whether this print actually fits a real car. Installed photos and material notes make the catalog more trustworthy.
Related Parts
Finding specific fitment/category matches first.
