Camry/Aurion Glovebox Latch Clips 06-11 XV40 - image

Files (2)

L_Glovebox_Clip_1.0.stl

STL

46.9 KB

R_Glovebox_Clip_1.0.stl

STL

63.2 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

2 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
L_Glovebox_Clip_1.0.stl	Clip	46.9 KB STL	Slice file	Slice file	Slice file	Print at 0.1mm or 0.2mm layer height for desired level of detail
R_Glovebox_Clip_1.0.stl	Clip	63.2 KB STL	Slice file	Slice file	Slice file	Print at 0.1mm or 0.2mm layer height for desired level of detail

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Interior

Camry/Aurion Glovebox Latch Clips 06-11 XV40

0 downloads26 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

The glovebox never closed properly in my Aurion. The previous owner must've taken out the clips at some point to remove screws and never reinstalled them. I could only find beige versions online for sale, They also had larger holes than the latch, so I would imagine the latch is quite sloppy in the hole. This contains Left and Right clip STL files, They are different sizes so you can't just mirror one. The clips print fine at.2mm, printed at 100mm/s with 70mm/s walls. 2 layer top and bottom. with accelleration at 1000mm/s on my ender 3. I did print the final versions that I'm using at.1mm with much slower speeds, as the overhangs on the clips don't droop. Aswell as the fact that it looks much smoother aestheticly. The.2mm versions do fit and snap in correctly, if you're not worried about the aesthetics you don't need to print fine or slow. There are a few little lips in the models as they were made in tinkercad and I couldn't be bothered cleaning them all up. They're such small lines they don't seem to print anyway.