Chevy Suburban/Tahoe phone holder - Galaxy S7 w/case - image

Files (2)

s7_sub2b.stl

STL

480.2 KB

s7_suburban2_clips.stl

STL

11.8 KB

Print guidance estimate

Estimated from part metadata

Print cost & setup estimate

Planning numbers for filament, cost, time, and setup. Treat them as estimates until you confirm the file in your slicer.

2 model files

Recommended kit

32g

Based on 25% main infill across listed model files

Material cost

$0.76

Filament only at roughly $24/kg PETG / ASA

Print time

54m–1.5h

Uses 70 mm/s, 0.2 mm layers; verify supports in slicer

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
s7_sub2b.stl	Printable file	480.2 KB STL	21g $0.50	23g $0.54	50g $1.19	Ensure a secure fit on the vent by adjusting the clip design if necessary
s7_suburban2_clips.stl	Clip	11.8 KB STL	8g $0.20	9g $0.22	20g $0.47	Small functional file: print slowly; consider 80–100% infill for durability.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Phone Mounts

Chevy Suburban/Tahoe phone holder - Galaxy S7 w/case

0 downloads43 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This is a 3-part assembly of two clips and a main bracket. It holds my Galaxy S7 w/case on the vent of my 2011 Chevy Suburban (also tested in Tahoe of similar vintage). My phone w/case on it is 74.5mm wide and 12mm thick, I can make main brackets with different cup sizes if you message me. Model was created in PTC Creo.