Delorean DMC-12 CTSY Light Switch Bracket - image

Files (3)

DMC12_1x_CTSY_Light_Switch_Bracket.stl

STL

34.8 KB

DMC12_2UP_CTSY_Light_Switch_Bracket.stl

STL

59.3 KB

DMC12_Mod_CTSY_Light_Switch_Bracket.stl

STL

32.3 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

3 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
DMC12_1x_CTSY_Light_Switch_Bracket.stl	Mount / bracket	34.8 KB STL	Slice file	Slice file	Slice file	Ensure a brim is used for stability during printing
DMC12_2UP_CTSY_Light_Switch_Bracket.stl	Mount / bracket	59.3 KB STL	Slice file	Slice file	Slice file	Ensure a brim is used for stability during printing
DMC12_Mod_CTSY_Light_Switch_Bracket.stl	Mount / bracket	32.3 KB STL	Slice file	Slice file	Slice file	Ensure a brim is used for stability during printing

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Interior

Delorean DMC-12 CTSY Light Switch Bracket

0 downloads24 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

Delorean DMC-12 Door light triggers (CTSY Light Switch) were angled downward causing the dash light (door open) and also the door lights to constantly illuminate and drain the battery. Door ajar alarm/buzzer was also affected. The plastic bracket that supports the switch provides little support and breaks over time (see first picture). I have an original replacement included here. Delorean store replacement (with switch) here: http://store.delorean.com/p-7013-ctsy-light-sw.aspx I also modified the original with a brim and a slotted hole for more stability. On the driver's side there are two switches. I merged the two individual brackets into a single '2UP' bracket for even greater stability/support. Also (edit: removed hole plug. It was terrible) Also also wik, notice that the 3d models have holes for the screws but the actual prints do not. While printing, the first several layers have an open hole. After those first few layers the hole is printed over. You can take a 5/32" drill bit to open them back up.