Dodge Challenger > 2015 trunk trim - image

Files (7)

connector.stl

STL

17.9 KB

corner_left.stl

STL

188.7 KB

corner_right.stl

STL

187.9 KB

inner_left.stl

STL

40.3 KB

inner_right.stl

STL

45.4 KB

outer_left.stl

STL

56.3 KB

outer_right.stl

STL

57.1 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

7 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
connector.stl	Accessory piece	17.9 KB STL	Slice file	Slice file	Slice file	Small functional file: print slowly; consider 80–100% infill for durability.
corner_left.stl	Choose left variant	188.7 KB STL	Slice file	Slice file	Slice file	Use PETG / ASA, 4 walls, 25% infill. Pick the matching side before printing.
corner_right.stl	Choose right variant	187.9 KB STL	Slice file	Slice file	Slice file	Use PETG / ASA, 4 walls, 25% infill. Pick the matching side before printing.
inner_left.stl	Choose left variant	40.3 KB STL	Slice file	Slice file	Slice file	Use PETG / ASA, 4 walls, 25% infill. Pick the matching side before printing.
inner_right.stl	Choose right variant	45.4 KB STL	Slice file	Slice file	Slice file	Use PETG / ASA, 4 walls, 25% infill. Pick the matching side before printing.
outer_left.stl	Choose left variant	56.3 KB STL	Slice file	Slice file	Slice file	Use PETG / ASA, 4 walls, 25% infill. Pick the matching side before printing.
outer_right.stl	Choose right variant	57.1 KB STL	Slice file	Slice file	Slice file	Use PETG / ASA, 4 walls, 25% infill. Pick the matching side before printing.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Trim Pieces

Dodge Challenger > 2015 trunk trim

0 downloads34 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

Upholstery in the trunk is hold to the back with a few push pins. At the corners there is some gaping. I like to keep the upholstery in good condition. This trim clamps onto the pushpins adding a edge and pushing the panel to the backside. I think this prevent it for damage.