Files (1)

Dodge_Magnum_Rocker_Panel_Clip.stl

STL

30.6 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
Dodge_Magnum_Rocker_Panel_Clip.stl	Clip	30.6 KB STL	Slice file	Slice file	Slice file	Print with the flat profile facing down to maintain the clip's springy functionality

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Side Skirts

Dodge Magnum Rocker Panel Clip

0 downloads41 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

When I needed two Dodge Magnum rocker panel clips, I found them to be conveniently available on the internet for low cost - but not just as fast as I would have liked. So I reverse-engineered them right quick and printed them using Carbon-PLA. Worked for me but I do not give any warranty. You do this you are on your own. Mount with care. Print correctly, print direction here is relevant. The tension of the springy part requires the profile of these to be flat on the printer so as to not get the layers to be perpendicular to the stem of the clip, see photo. Full story here: http://www.swisswuff.ch/wordpress/?p=1561