Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

0 model files

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	ASA / ABS 20%	ASA / ABS 25%	100% solid	Recommendation
No printable model files are available for an estimate yet.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Mechanical/Functional

DTA ECU Bracket (S60/S80/S100)

0 downloads42 views0 likes

Download at source

Shared by

3DPrintedCarPart

Verified

Description

Here is my solution to the DTA S60, S80 and S100 mounting dilemma. A pair of identical rectangular brackets which slip over the each end of the ECU, and accept a M5 or M6 hex socket cap bolts which allow the brackets to be solidly mounted to your vehicle, or in my case, through a set of four M6 female to male anti vibration mounts. I printed this in Sunlu ABS Be sure to rotate the part to print laid flat rather than upright. Support might be needed for the bolt holes, be careful removing that upon completion.