F100 Crown Vic - Headlight Adapter - image

Files (3)

CV-53_Headlight_Adapter_Knob.stl

STL

132.9 KB

CV-53_Headlight_Adapter_Nut-P.stl

STL

13.8 KB

CV-53_Headlight_Adapter_Top.stl

STL

78.4 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

3 model files

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
CV-53_Headlight_Adapter_Knob.stl	Printable file	132.9 KB STL	Slice file	Slice file	Slice file	Ensure proper alignment of the knob with the inserts on the base during installation
CV-53_Headlight_Adapter_Nut-P.stl	Accessory piece	13.8 KB STL	Slice file	Slice file	Slice file	Small functional file: print slowly; consider 80–100% infill for durability.
CV-53_Headlight_Adapter_Top.stl	Printable file	78.4 KB STL	Slice file	Slice file	Slice file	Ensure proper alignment of the knob with the inserts on the base during installation

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Knobs/Buttons

F100 Crown Vic - Headlight Adapter

0 downloads37 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

These files allow you to take the factory CV headlight switch and adapt it to use the F100 stock looking headlight setup.... 1. Remove the stock Knob and cut the shaft about halfway. 2. Remove the knob from the F100 Shaft and cut the shaft to fit (I think its about half) 3. Hammer the shaft into the new Knob (A hole is there incase you want to drill a screw hole) 4. Install the new knob (Make sure to align it with the inserts on the base) 5. Insert a nut into the top plate that has threads that fit the Headlight Bolt 6. Install the top plate over the notch and 2 stock screws 7. Install the headlight switch in the stock location of the original switch or next hole over.