Fiat 500 Abarth Boost Gauge Adapter for 52mm Gauge - image

Files (4)

52mm_Face_Plate.step

STEP

341.6 KB

52mm_Face_Plate.stl

STL

1.3 MB

52mm_Spacer.step

STEP

25.9 KB

52mm_Spacer.stl

STL

170.2 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

4 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
52mm_Face_Plate.step	Printable file	341.6 KB STEP	Slice file	Slice file	Slice file	Ensure proper orientation in the slicer to minimize supports
52mm_Face_Plate.stl	Printable file	1.3 MB STL	Slice file	Slice file	Slice file	Ensure proper orientation in the slicer to minimize supports
52mm_Spacer.step	Printable file	25.9 KB STEP	Slice file	Slice file	Slice file	Ensure proper orientation in the slicer to minimize supports
52mm_Spacer.stl	Printable file	170.2 KB STL	Slice file	Slice file	Slice file	Ensure proper orientation in the slicer to minimize supports

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Dashboard

Fiat 500 Abarth Boost Gauge Adapter for 52mm Gauge

0 downloads39 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

This is a two piece adapter that allows you to replace the factory boost gauge in your Fiat 500 Abarth with any 52mm gauge. I am going to use a AEM OBDll Gauge. My final version will have an aluminum face plate but for prototyping I'll use the printed FP. The Spacer was designed as a printed part. Assemble it use the factory back plate from the gauge and three M3 x 30mm screws. You will need to tap the face plate to accept the screws. I will post picture of the finished assembly as soon as the gauge arrives.