Files (1)

tinker.obj

OBJ

14.4 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
tinker.obj	Primary model	14.4 KB OBJ	Slice file	Slice file	Slice file	Small functional file: print slowly; consider 80–100% infill for durability.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Interior

Fiat 500 Armrest Mount

0 downloads31 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

My Fiat 500 armrest clips broke off and the top of my armrests completely detached from their bases. I designed these mounts which slide in to the base and into the tops to hold everything in place tightly. Use super glue or plastic glue to permanently keep everything secured. Its a tight fit, so a little tricky to get them on, but once they're in place it holds pretty well even without glue. I know this is a common problem for 500's so I hope this helps many of you! One print is a set for a single armrest.