Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

0 model files

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
No printable model files are available for an estimate yet.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Light Covers

Fog light - DRL Adapter

0 downloads50 views0 likes

Download at source

Shared by

3DPrintedCarPart

Verified

Description

Hi! I designed this adapter to fit the Magneti Marelli 713120117010 90mm round led drl to the stock fog light mounting points of my '07 Citroen Jumper X250. I just had to remove a pin at each mounting point and cut a 90mm hole where the fog lights usually sit. Hardware needed: 8x M3 x 15 cylinder head screws 8x large washer for M3 screws 4x M5 x 18 cylinder head screws 4x washers for M5 screws Ignition activated power for the lights can be taken from pin 85 from the relais T14 in the fuse box in the motor area. Don't forget the fuse! Pictures will follow! Hope you enjoy!