Stop / Trurn indicator housing Critroen 2CV Citronnete Mehari - image

Files (1)

giro.obj

OBJ

190.6 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
giro.obj	Primary model	190.6 KB OBJ	Slice file	Slice file	Slice file	Ensure proper ventilation when printing with PETG or ASA

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Light Covers

Stop / Trurn indicator housing Critroen 2CV Citronnete Mehari

0 downloads98 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

Stop/parking signal use 3W star led on 1W (3*180Ohms parallel, 1W Each) for stop an 0.25W (180Ohms 1W, single) for parking (more power blind back drivers). Turn signal use 3W Yellow led on 0.5W ( 2*180Ohms parallel) Is recommended to place a low value capacitor in parallel with led (1uF no polarized) and a diode for reverse polarity protection. Seal with black silicone (fastix) to prevent moisture (no need to change a light for a lifetime of the assembly). Its optimal to use a switch-mode power supply for leds, but because of the low power compares to stock lights its no much sense to make further optimization but it improves consumption. Current efficiency with resistors is 34%. Use Silicone sealant to fix the LED to heat-sink, because of the low power involved is enough thermal efficiency.