FORD EXPLORER 2003 HEADLIGHT SWITCH/KNOB - image

Files (1)

HEADLIGHT_SWITCH_EXPLORER_2003_SHAFT_FIT_TEST.STL

STL

159.8 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

1 model file

Recommended kit

Slice required

Slice the required model files; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
HEADLIGHT_SWITCH_EXPLORER_2003_SHAFT_FIT_TEST.STL	Primary model	159.8 KB STL	Slice file	Slice file	Slice file	Print the model upside down to avoid support material inside the shaft

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Knobs/Buttons

FORD EXPLORER 2003 HEADLIGHT SWITCH/KNOB

0 downloads36 views0 likes

Shared by

3DPrintedCarPart

Verified

Description

I snapped the original switch,so I made this new one for my bigger hands. You will need the metal insert that was inside the original knob (apply pressure to install), so if you don't have that this might not fit. Be sure to print this model upside down (Check Cura JPEG) or else you'll end up with support material inside the shaft. I won't be able to post real pictures because I just lost my phone:(.